Schedule Your Dryer Repair Today!

Possible Causes:

• Power issue (plug, breaker, outlet)
• Door switch not engaging
• Faulty start switch
• Bad control board or timer

Troubleshooting Steps:

• Confirm the dryer is plugged in and outlet is working (test with another appliance).
• Reset the circuit breaker: Even if it doesn’t look tripped, flip it off and on.
• Open and close the door: Listen for the “click” from the door switch. If missing, test switch with multimeter.
• Check the start switch for continuity. Replace if it fails.
• Inspect terminal block and wiring for burns or loose connections.

Possible Causes:

• Blocked or crushed vent hose
• Dirty lint screen
• Faulty moisture sensor
• Broken heating element

Troubleshooting Steps:

• Clean the lint screen thoroughly: Even detergent residue can reduce airflow.
• Inspect the vent hose: Remove and check for kinks or heavy lint buildup.
• Run dryer with vent disconnected: If drying improves, airflow is blocked.
• Check moisture sensor (metal bars inside drum): Clean with rubbing alcohol to remove residue.
• Inspect the heating element.

Possible Causes:

• Worn drum support rollers, bearings, or belt
• Loose or foreign objects inside drum
• Idler pulley or motor noise

Troubleshooting Steps:

• Turn the drum manually: Listen for grinding or resistance.
• Look inside the drum for coins, buttons, or objects in the drum baffles.
• Remove the dryer panel and inspect the rollers, belt, and idler pulley.
• Replace worn components (usually comes as a maintenance kit).

Possible Causes:

• Blocked vent or lint filter
• Faulty high-limit thermostat
• Defective heating element stuck “on”
• Sensor failure

Troubleshooting Steps:

• Clean vent system completely (from dryer to exterior).
• Test high-limit thermostat and thermal cutoff with a multimeter.
• Check heating element for grounding issues (touching the dryer housing).
• Replace bad thermostats or sensors if out of spec.

Possible Causes:

• Heating circuit failure
• Clogged vent reducing efficiency

Troubleshooting Steps:

• Run dryer on timed dry with high heat: No heat = electrical or gas problem.
• Check for airflow at the outside vent: Weak flow = vent blockage.
• Use a multimeter to test thermal fuse, element and thermostats.

Possible Causes:

• Overheating due to vent blockage
• Moisture sensor error
• Faulty motor or relay
• Timer or control board issue

Troubleshooting Steps:

• Clean the entire exhaust system: Blockage can cause overheating and premature shut-off.
• Clean and test moisture sensors: Wipe with a damp cloth and test for continuity.
• Listen for motor overheating: It may cut out due to thermal overload.
• Try a timed dry cycle: If it runs longer than sensor dry, suspect the sensor or control board.

Possible Causes:

• Uneven floor or unbalanced load
• Worn drum support rollers
• Missing leveling legs

Troubleshooting Steps:

• Ensure dryer is level: Adjust feet until stable.
• Don’t overload the drum: Especially with large, heavy items.
• Inspect supports: Replace worn rollers or pads to reduce vibration.
• Use anti-vibration pads under feet if on hard flooring.

Possible Causes:

• Lint buildup inside the machine
• Debris on heating element
• Overheating components

Troubleshooting Steps:

• Unplug dryer immediately if you smell burning.
• Open up the dryer cabinet and inspect for lint near the motor or heater.
• Vacuum inside thoroughly.
• Run a short test cycle to check for smell return.

If burning smell persists, have it serviced professionally.